 Introduction :
|
|
ST-1 STOVE ENAMEL is an Alkyd -Amino System. This has been specially
formulated system to give a non-yellowing property, high gloss and hard and durable finish. It is very good
protective and decorative stoving enamel.
|
|
The range of Application : |
|
This system is excellent for home appliances, electrical fittings,
toyes, and automobile industries It can be used for steel furniture, control panels, machinery's etc.
Resistance to oils, waters, solvents, alcohol's and limited tolerance to
kenotic solvents gives this system wide range of applications.
|
|
|
Key Properties
:
|
|
• |
Ability to be cured twice without any shade variation ( Stipple
finishes are possible ) |
• |
Excellent adhesion and flexibility and hardness. |
• |
Good mechanical strength. |
• |
Resistance to chemicals and water (direct immersion in chemicals is
not advisable ) |
• |
Excellent mar resistance. |
• |
Resistance to Aliphatic Aromatic solvents, Alcohols, Grease and
fats.( Direct immersion is not advisable ) |
• |
Unaffected by oils and detergents. |
|
|
|
Application :
|
|
|
Before application of top coat ST-1 Stove Enamel do all necessary
pretreatment of the Job.For M.S.surface, remove grease Oil and other contamination by using degreasing agent. Blast cleans the
surface for heavy rusting. Use derusting chemicals to clean the surface.
Phosphating and passivation should be done. Apply TC Yellow Zinc
Chromate Primer or Red Oxide Zinc Chromate Primer. Stove or Air-dry
above primer coat. Them remove the excess coating of primer and get
10-15 micron DFT .Apply second coat of TC Primer surface Grey or surface
Grey-green ( Stoving or Air drying type ) Again remove excess coat. Fill up the putty if necessary. Proper curing
of all primer coats and putties essential before application of ST-1 stov Enamel to get proper adhesion. Stir the ST-1 stov Enamel thoroughly reduce the viscosity of paint by
using TC/ST -101 thinner to 25-20 sec.Stoving of the top coat at 120o C for 30 minutes. For stipple finish keep
the viscosity 30-35 sec by B 4 Cup & apply at very low pressure to get std.pattern. After using the paint close the container immediately to avoid the
solvent losses and moisture absorption in material. Do not apply in
humid condition, during raining or mist and fog or at very low
temperature.
|
|
| |
|
|
|
|
|
